MILLERCADE (almost done!) with rotating control panel set to Joysticks.

Sunday, August 24, 2008

The Axle

Here you see the concept in place. I used a 1” PVC pipe for the axle. Being hollow it also allows for the wires to get outside of the rotating drum by passing them inside it. The wires travel loose in the pipe for 14 inches, being restricted only at either end, meaning the maximum twist of 120 degrees is distributed out over that length, bring the actual twist on the wires to a minor 8 degrees per inch, well within the wire’s tolerance. The only wires that had to pass through this conduit were:

1. PS2 extension.
2. USB extension.
3. 13 wires (1 ground, 2 ‘coin’ buttons, P1Start and P2Start, coin LED, 12 volt power, 5 volt power, extras for unforeseen whoknowswhat) which all need to get back to the IPAC2 inside the drum.

No comments: